Versions Compared

Version Old Version 1 New Version Current
Changes made by

Aric Malsbury

Aric Malsbury

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Excerpt

Sometimes the PVE website may need to be re-installed due to bad credentials,

settings, or invalid access rights. This procedure will help you re-build the PVE website on a clean slate

Getting Started

Be sure that...

  • You have access to the environment that hosts the PVE website.
  • Basic knowledge over IIS and Papervision Enterprise

Run Command Prompt As Admin

  1. Click Start → type in "CMD" and right click CMD and click "Run as Administrator"

Get Location of Configuration Utility

Navigate to C

change in configuration or you skipped the installation prior. This is only needed if an article or technician recommends the re-installation of the PVE Website.

Running the Wizard

Getting Started

  1. You will need to log on to the server that has PaperVision Enterprise installed.

  2. You’ve picked an IP endpoint and port you wish to use for PVE traffic.

  3. If you’re not hosting any other websites over the default HTTP port 80, you can rebind the default site to something else and use port 80 in your wizard.

Run the Website Creation Utility

Info

It is recommended to run the wizard under the service account that will be used by the PVE Website and automation services. Basic rights should have access to the database for PVE, read/write to IIS configuration and files.

Info

If you installed PVE under a different location, adjust the command below to reflect on the proper location for the wizard utility.

  1. Open a command prompt as an administrator.

  2. Navigate to “C:\Program Files (x86)\Digitech Systems\PaperVision\

Common and locate file "DSI.PVEConfiguration.Utility.exe"
  • hold shift and right click on the file and click "Copy as path"

    • Image Removed

    Run Utility

    Right click → paste inside the command prompt running as administrator and add "/createsite" at the end of the command. Example belowcode

    1. Common” folder.

    2. Enter the following command below to run the wizard:

    Code Block
    languagebash
    "C:\Program Files (x86)\Digitech Systems\PaperVision\Common\DSI.PVEConfiguration.Utility.exe" /createsite

    1. Follow

    instructions given by the prompt

    Website Configuration

  • Check "Configure Web Site"
  • Set description and IP address to your liking or leave as default
  • Provide a valid domain/user account that has rights to IIS and provide the username and password for that account.
  • Click "Next"
    • Info

    It will take 1-5 minutes to process, once it is completed, it will present an installation successful

  • The website is now installed and should be accessible
    • Panel
    Panel

    Table of Contents

    Table of Contents
    maxLevel1
    excludeTable of Contents

    Panel

    Related Documents

    Filter by label (Content by label)
    showLabelsfalse
    max5
    showSpacefalse
    cqllabel in ("getting-started","procedure","helpdesk-ticket")

    Panel

    Helpful Resources

    Helpful Links and Resources

    1. the prompt as usual to create your PVE website and Auth Gateway(if necessary).